[dvschnk]

mr_brady, did you get the conservative govenor to work after you finally got it to install. I'm on Liberty 3 2.0, for DX, and I can't get the conservative govenor to show up anywhere...I usually use quickclock, but its also not in liberty's own govenor selector. All I have is ondemand, userspace, and performace. For BMc08GT, I flashed the flashme.zip, and even in the togglemods, it says the conservative govenor is on. It is the only mod that I have installed right now.

 

[dvschnk]

Did you instal then flash flashme.zip then reboot then toggle? Mine shows up in setcpu and QC just fine. If it's done out if order it won't show but will say it's toggled

I installed, and chose only the conservative govenor, which created the flashme.zip. I rebooted into recovery, and flashed the zip. Upon startup, I ran toggemods, and turned on the conservative govenor. Rebooted. Then no conservative govenor. If I'm reading your post right, I need to flash flashme.zip, start back up, reboot again, then do togglemods, turn the govenor on, reboot, then profit

.